50mm 4.5g Heavy Sinking
[Baby Corn Minnow 50HS] Heavy sinking minnow A mountain stream model of the DeeDeeDesigns corn minnow series. A heavy sinking minnow that pursues ease of use in terms of size, weight, and performance. In terms of performance, it has a heavy sinking weight of 4.5g at 50mm, sinks horizontally while swinging its body, and responds instantly to rod work considering its weight.
Since it sinks under its own weight, the lip and body balance prevent it from diving too deep, reducing the chance of it getting entangled due to diving too deep. Everything is set at just the right balance. It took over a year from the start of development to get this far. Making full use of the advantages of the biodegradable plastic material produced by 3D printer molding, the baby corn minnow is finished with a one-piece structure pasted up to the lip, and the eye is made into an extremely small eight ring to avoid affecting swimming as much as possible.
In strength tests, the strength shown by the toughness and tenacity of reinforced PLA is overwhelming. Even though the lip looked thin, it didn't break even after hitting it against rocks a few times. The strength of being able to cast without hesitation to points that are more difficult to aim at will surely lead to better fishing results. Another feature is that the lipstick is colored, making it highly visible. Even though it is a 3DPL lure, the assembly, polishing, painting, and coating are done by hand by craftsmen, so it is true that each lure has its own individuality. It has been confirmed that its uniqueness causes irregular actions and turns on the fish.
We have a variety of colors available, from standard colors to pop colors typical of DDD, so be sure to brighten up your tackle box and catch memorable fish. - New material: The PLA resin used in this lure is a strong PLA resin that has up to 9 times the impact resistance of regular PLA resin. (Biodegradable resin)
[SPEC]
Length: 50mm
Weight: 4.5g
Type: Heavy Sinking Minnow
Recommended Hook:TrebleHook #12
Single Hook: #8
Filament: Reinforced PLA (polylactic acid made from plant-derived ingredients) [Note] * Comes with split ring, hook not included. *This lure does not use plastic packaging for environmental reasons. *This lure is molded using a 3D printer using Fused Deposition Modeling, so there are traces of lamination on the lure itself. *As the heat resistance is slightly weaker than general plastic lures, please be careful not to expose it to direct sunlight for a long time, especially in the summer. There is a risk of deformation. *PLA resin is biodegradable, but it will not decompose unless it is placed in compost, so please use and store it with confidence.
