| Handle pitch (width) |
65mm |
| Weight (approx.) |
Daiwa compatible 12.1g
Shimano compatible 12.6g
|
| Handle material |
Extra super duralumin |
| Knob type |
Acrylic knob |
ZEROGRA double handle + balancer IV modified
This time, I changed the ZEROGRA Double Handle IV knob from 8.00mm to 9.90mm.
By making it 1.9mm thicker, it is easier to grip.
It can powerfully handle unexpected large prey, and is less tiring to use for long periods of time.
The material used is the same acrylic as before.
The big advantage of acrylic is that it is light and hard. Hardness naturally improves sensitivity.
The plates and shafts are machined from ultra-super duralumin, and every last detail has been hollowed out.
The result was excellent.
Circle-exclusive colors: Majora Pink Black
Handle pitch (width): 65mm
Weight (approx.): Daiwa compatible 12.1g, Shimano compatible 12.6g
Handle material: Super duralumin
Knob Type: Acrylic knob
Special tool included If the knob nut becomes loose, please use the special tool provided.
It is possible to tighten it with a hex wrench, but please be careful not to overtighten it as this may result in damage.
ーーーーーーーーーーーーーーーーーーーーーーーーーーーーーーーーーーーー
Precautions for use: The handle is a very delicate product.
There is no problem with its strength under normal use, but if it is dropped or hit, the handle may bend or the knob may crack. Please handle with care.
This knob is thin and does not have centrifugal force, so at first glance it may seem difficult to turn, but this does not affect its use in any way.
Please attach the plastic skirt with the top side (knob side) raised. After attaching, lower it to a position where it does not hit the reel to prevent foreign objects from entering.
If you attach it in the lowered position, the skirt will come into contact with the reel and the handle will not turn.
Please be careful as this may result in damage to the skirt.
The screws may come loose during use, so we recommend tightening the three outer screws (2 handle knobs, center screw) approximately once every 2-3 months (the knob screws can be tightened with the included special tool).
The center nut can be tightened with a 4mm hex wrench. Please be careful not to overtighten it, as this may damage it.
[34 Staff Introduction]
34 Instructor: Yonemoto Instagram is here
34 Instructor: Taiki Instagram is here
34 Instructor: Hiro Instagram is here
